· Electronic speed control
· Pipe racks
· Oil cooler
· Breakout wrench hydraulic cylinder
· Front hydraulic outrigger jack
· Extended mast height
· Corded remote control
· Wireless remote control
· Mast lights
· Walking beam
· Special paint colors
· Line-X spray-on bed liner
· Headache rack
· Wire winder
· Power to the rear
· Other options are available on request
The 10T pump hoist with 27,000 lbs. capacity and a 36 ft. high telescoping mast is designed to mount on a 2 ton or larger truck. Fast and easy setup by means of a self supporting mast with four 3 1/2" bore hydraulic cylinders. A guy cable is not needed in most situations. Designed to allow for easy access to hard-to-get-to pumps. Total pump hoist weight is approximately 7,000 lbs. A deck, headache rack and toolboxes add approximately 3,000 lbs.
Mast: 36 ft. high telescoping mast with 11 ft. maximum layback
Capacity: 9,000 lbs. single line, 27,000 lbs. with 3 part line
Mainline speed: 140 feet per minute
Mainline cable: 5/8" X 150'
The mainline spool is driven by a heavy duty pinion gear with the pinion shaft direct coupled to the hydraulic motor. Braking is accomplished with a Hunke automatic fail safe brake. The winch drum has a cable storage section with enough drum width to spool a 3 part line on a bare drum.
The tailout winch has a 2,500 lb. lifting capacity at 150 feet per minute and uses a fail-safe brake. Tailout cable: 3/8" x 125 ft.
Line Block: Blocks for reeving a 2 part or 3 part line
Hooks: 7 ton and 15 ton safety hooks
PTO for standard transmission (PTO is available for an automatic at additional cost)
Hydraulic pump: 2 stage gear pump
The pump hoist is designed to mount on a deck
Open frame design allows for full use of the deck area
Operating controls are conveniently located at the left rear corner of the rig and are accessible from ground level
Hydraulic bypass valves are incorporated to protect from overloading
Rear hydraulic outriggers with holding valves
Holding valve on mast cylinders
White or gray paint - Standard
Sandline winch: 2,500 lb. bare spool lifting capacity with 450 feet per minute line speed. It is power-up and power-down. Braking is accomplished with a Hunke automatic fail safe brake. Spool capacity: 1,900 ft. of 1/2" cable, 2,500 ft. of 7/16" cable or 3,400 ft. of 3/8" cable.